MFI Custom Thread SOCOM Fake Silencer BLANK for Sig Mosquito & Other Handguns

Fake Silencers are also known as: Dummy Can, Faux Suppressor, Mock Silencer, Barrel Shroud & Non Functional Sound Suppressor.

These are designed for LIVE FIRING.

We test all our Fake Silencers to be 100% sure that they function shot after shot without any problems.

This product fits NOT only the SIG Sauer Mosquito .22 Cal. LR, but we also offer FREE Re-Tapping of the small 9mm hole to the following larger thread patterns:

• 9/16 X 24 Left Hand
• 1/2 X 28 Right Hand
• 1/2 X 32 Right Hand
• 1/2 X 36 Right Hand
• 5/8 X 24 Right Hand
• 0.578 X 28 Right Hand
• 0.595 X 32 Right Hand
• 10mm X 1.0 Right Hand
• 12mm X 1.0 Right Hand
• 13mm X 1.0 Right Hand
• 13mm X 1.0 Left Hand
• 13.5mm X 1.0 Right Hand
• 13.5mm X 1.0 Left Hand
• 14mm X 1.0 Right Hand
• 14mm X 1.0 Left Hand
• 14.5mm X 1.0 Right Hand
• 14.5mm X 1.0 Left Hand
• 15mm X 1.0 Right Hand

---

This Version of the MFI SOCOM Fake Silencer is U-Marked / BLANK.

What makes the MFI SOCOM Fake Silencers (SOCOM Mosquito / Custom Thread) UNIQUE from all other real or fake silencers is:

The LETTERING / MARKINGS are INDEXABLE to the CORRECT POSITION! (Assuming you have it engraved as well) As you may not realize all threaded barrels and silencers have different starting and ending points on the threads. Thus you could have 5 identical weapons all made at the same time and the same silencer or flash suppressor will NOT end up at the same point on each weapon. This is why you get a peel washer with your AR15 flash suppressor (peels off 10 /1000th of an inch) so you can correctly index your suppressor to the individual weapon.

So what we are saying is... No matter how many weapons you have... You will ALWAYS be able to get the lettering / U.S. GOV. markings in the exact location that you want them. This is because there is a set screw is hidden in the bottom of the end cap (see the "x")that allows the outer body to rotate 360 degrees around the inner barrel. First tighten the set screw and then thread the fake silencer on your weapon. Then loosen the set screw and continue the rotation as if to tighten / go on direction... Position the Laser Markings to the correct location & re-tighten the set screw.

You can screw on & off the Fake Silencer and NEVER have to reset the letters / set screw. Obviously this set up is for an individual / specific weapon so if you move the fake silencer to a different weapon you will most likely have to re-index the outer body again.

---